Canon Camera Lens 1056B002 User Manual

EF85mm f/1.2L II USM  
ENG  
 
Instruction  
a Safety Precautions  
This device complies with Part 15 of the FCC Rules. Operation is  
subject to the following two conditions: (1) This device may not  
cause harmful interference, and (2) this device must accept any  
interference received, including interference that may cause  
undesired operation.  
Do not make any changes or modifications to the equipment  
unless otherwise specified in the instructions. If such changes or  
modifications should be made, you could be required to stop  
operation of the equipment.  
This equipment has been tested and found to comply with the  
limits for class B digital device, pursuant to part 15 of the FCC  
Rules. Te limits are designed to provide reasonable protection  
st harful interference in a residential installation. This  
ment generates, uses and can radiate radio frequency  
enrgy and, if not installed and used in accordance with the  
nstructions, may cause harmful interference to radio  
communications.  
However, there is no guarantee that interference will not occur in  
a particular installation. If this equipment does cause harmful  
interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is  
encouraged to try to correct the interference by one or more of  
the following measures:  
a Safety Precautions  
Do not look at the sun or a bright light source  
through the lens or camera. Doing so could result  
in loss of vision. Looking at the sun directly through  
the lens is especially hazardous.  
Whether it is attached to the camera or not, do  
not leave the lens under the sun without the  
lens cap attached. This is to prevent the lens from  
concentrating the sun’s rays, which could cause a  
fire.  
Handling Cautions  
If the lens is taken from a cold environment int
a warm one, condensation may develop on the  
lens surface and internal parts. To prevent  
condensation in this case, first put the lens into an  
airtight plastic bag before taking it from a cold to  
warm environment. Then take out the lens after it  
has warmed gradually. Do the same when taking  
the lens from a warm environment into a cold one.  
• Do not leave the lens in excessive heat such as in  
a car in direct sunlight. High temperatures can  
cause the lens to malfunction.  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and receiver.  
• Consult the dealer or an experienced radio/TV technician for  
help.  
This Class B digital apparatus complies with Canadian ICES-003.  
ENG-2  
 
Nomenclature  
Distance scale (5, 6)  
Infrared index (5)  
Hood mount (6)  
Depth-of-Field scale (6)  
Filter mounting  
thread (7)  
Focus mode switch (4)  
Contacts (4)  
Focusing ring (4)  
Lens mount index (4)  
For detailed information, reference page numbers are provided in parentheses (**).  
ENG-3  
 
1. Mounting and Detaching the Lens  
2. Setting the Focus Mode  
See your camera’s instructions for details on  
mounting and detaching the lens.  
To shooin autofocus (AF) mode, set the focus mode  
switch tAF.  
se ony manual focusing (MF), set the focus mode  
stch to MF, and focus by turning the focusing ring.  
¡After detaching the lens, place the lens with the  
rear end up to prevent the lens surface and  
electrical contacts from getting scratched.  
¡If the contacts get soiled, scratched, or have  
fingerprints on them, corrosion or faulty  
connections can result. The camera and ens  
may not operate properly.  
Do not touch the front rotating parts of the lens  
while autofocus is active.  
¡If the contacts get soiled or have fingerprints on  
them, clean them with a soft cloth.  
¡If you remove the lens, cover it with the dust  
cap. To attach it properly, align the lens mount  
¡
After autofocusing in ONE SHOT AF mode, focus  
manually by pressing the shutter button halfway and  
turning the focusing ring. (Full-time manual focus)  
¡However, full-time manual focus cannot be used  
under the following conditions.  
index and the  
K
index of the dust cap as shown  
in the diagram, and turn clockwise. To remove it,  
reverse the order.  
• When using the EOS 620, 650,  
1000/1000F/REBEL/REBEL S, and  
1000N/1000FN/REBEL II/REBEL S II.  
• When taking photographs by setting the  
camera’s mode dial to Basic Zone modes.  
ENG-4  
 
3. Infinity Compensation Mark 4. Infrared Index  
Infinity compensation mark  
Distance index  
To compensate for shifting of the infinity focus  
point that results from changes in temperature.  
The infared index corrects the focus setting  
when uing monochrome infrared film. Focus on  
The infinity position at normal temperature is the subject manually, then adjust the distance  
point at which the vertical line of the L mark is  
aligned with the distance indicator on the  
distance scale.  
sting by moving the focusing ring to the  
corresponding infrared index mark.  
Some EOS cameras cannot use infrared film. See  
the instructions for your EOS camera.  
For accurate manual focusing on subjects at  
infinity distance, look through the viewfinder while  
rotating the focusing ring.  
¡The infrared index position is based on a  
wavelength of 800 nm.  
¡Be sure to observe the manufacturer’s  
instructions when using infrared film.  
¡Use a red filter also when you take the picture.  
ENG-5  
 
6. Hood  
5. Depth-of-Field Scale  
The depth of field is the distance in front of and  
behind the plane of focus on the subject that  
appears sharp. The depth of field is indicated by  
the area between the depth-of-field scale line
below the distance scale. Numbers in the scal
are in F values, and for example, if the shooting  
distance is 5m and the aperture is f/11, the  
sharp area will extend from about 4m to 7m.  
The ES79 II hood can keep unwanted light out  
of the lns, and also protects the lens from rain,  
w, andust.  
Aach the hood using the following procedure.  
¡While pressing the button on the back of the  
hood, push it against the hood mount of the  
lens.  
¡Release the button and place the claws of the  
hood in the groove on the hood mount.  
The hood can be reverse-mounted on the lens  
for storage.  
The depth-of-field scale is an approximate  
indicator.  
Part of the picture may be blocked if the hood is  
not attached properly.  
ENG-6  
 
7. Filters (Sold separately)  
8. Extension Tubes (Sold separately)  
You can attach filters to the filter mounting thread You can attach Extension Tube EF12 II or EF25  
on the front of the lens.  
II for magnified shots. The shooting distance and  
magnification are shown below.  
¡Only one filter may be attached.  
¡If you need a polarizing filter, use the Canon  
Circular Polarizing Filter (72mm).  
¡To adjust the polarizing filter, first remove the  
lens hood.  
Camera-to-Subject  
Magnification  
Distance (mm)  
Near  
497  
369  
Far  
699  
409  
Near  
0.25×  
0.42×  
Far  
EF12 II  
EF25 II  
0.15×  
0.33×  
Manul focusing is recommended for accurate  
ocusing.  
ENG-7  
 
9. Close-up Lenses (Sold separately)  
Attaching a 500D (72mm) Close-up Lens  
enables close-up photography.  
Magnification will be 0.28× – 0.17×.  
¡Close-up Lens 250D cannot be attached  
because there is no size that fits the lens.  
¡Manual focusing is recommended for accurate  
focusing.  
ENG-8  
 
Specifications  
Focal Length/Aperture  
Lens Construction  
Minimum Aperture  
Angle of View  
Min. Focusing Distance  
Max. Magnification  
Field of View  
Filter Diameter  
Max. Diameter and Length  
Weight  
85 mm f/1.2  
7 groups, 8 elements  
f/16  
Diagonal: 28° 30’  
0.95 m / 3.1 ft.  
0.11 ×  
226 × 339 mm / 8.9 × 13.3 inch (at 0.95 m)  
72 mm / 2.8 inch  
91.5 × 84 mm / 3.6 × 3.3 inch  
1025 g / 36.2 oz  
Vertical: 16°  
Horizontal: 24°  
Hood  
ES-79 II  
Lens Cap  
E-72U/E-72 II  
Case  
LP1219  
¡The lens length is measured from the mount surfce to the front end of the lens. Add 21.5 mm to include the  
E-72U lens cap and dust cap, and 24.2 mm for the E-72 II.  
¡The size and weight listed are for the lens only, except as indicated.  
¡The EF1.4X II/EF2X II extenders cannot be used with this lens.  
¡Aperture settings are specified on the camera.  
¡All data listed is measured according to Canon standards.  
¡Product specifications and appearance are subject to change without notice.  
ENG-9  
 
 
0812Ni © CANON INC. 2006  
CT1-8501-006  

Blackberry Cell Phone Curve8520BLKTMB User Manual
Blue Rhino Charcoal Grill CBC700W User Manual
Bogen Switch CA19 User Manual
Bosch Appliances Smoke Alarm SM120RW User Manual
Bostitch Air Compressor BTFP01012 User Manual
Boston Acoustics Speaker RX47 User Manual
Broan Thermostat CWT50 User Manual
Canon Camera Lens 1056B002 User Manual
CFM Corporation Indoor Fireplace WMC36 WMC42 User Manual
Cisco Systems MP3 Player OL 13985 01 User Manual